Compared to catheters with
other methods of lubrication,
innovative catheters with
a hydrophillic coating result
in the lowest incidence of
complications connected
to intermittent catheterisation.
Catheters with a hydrophilic coating
The hydrophilic coating is a layer of polyvinylpyrrolidone (PVP) located on the surface of some catheters’ tubes, which becomes very slippery in contact with water. It absorbs ten times the weight of the water and creates a slippery layer, similar to the urethral mucosa.
Sterile water is required to activate the hydrophilic coating. Before being inserted into the urethra, the catheter is soaked into water for 30 seconds. It absorbs water and becomes very slippery. Friction of the catheter tube is thereby greatly reduced.
Research has shown:
Are there different types of hydrophilic layers?
The longer the drainage time and the longer the catheter is inserted into the urethra, the lower the friction in catheters with a more stable hydrophilic layer will be.
The mucous membrane of the urethra acts as a semipermeable membrane, which also absorbs water from the hydrophilic layer. This means that the urethral mucosa will draw water from the hydrophilic layer and the longer the catheter is inserted into the urethra, the less slippery the layer bill be.
Do not leave a catheter with the hydrophilic layer in the urethra for more than ten minutes as it may start to stick to the urethral wall. The hydrophilic layer is reactivated by soaking in water. However, re-irrigation is not recommended as the catheter is disposable and, if used multiple times, it creates a higher risk of a urinary tract infection.
The quality of hydrophilic layers differs between different catheter manufacturers. Drying time of the hydrophilic layer is important as it determines how long the catheter can be left in the urethra before it dries and sticks to the urethral wall.
Why is lubrication of the catheter with a hydrophilic layer better than gel?
The hydrophilic layer is factory-integrated on the surface of the catheter tube and does not swipe off the surface during catheterization. Even if you try to remove it by hand, you will not succeed.
The opposite happens with catheters to which gel is applied, since by adding friction to the surface of the tube (for example when inserting a catheter into the urethra) the gel is wiped off the surface and the catheter tube remains dry. This is especially important in men who have a long urethra, as the gel catheter in this case gets into the bladder inadequately lubricated and causes damage to the urethra.
Conclusion
Catheters with a hydrophilic layer on the surface reduce the possibility of complications related to intermittent catheterization, such as urinary tract infections caused by contamination and discomfort.
Return to other articles
Please complete your details and where you would like your samples to be delivered. We handle and ship your samples free of charge.
Tell about yourself *
First Name *
Last Name *
What products are you using?
Email address *
Phone
Address *
Zip Code *
City *
Country *
GDPR*